 | Volvo Penta's control cables are manufactured of corrosion-resistant material with an outer sheath of HD polyethylene. They are designed following Volvo Penta's extremely stringent requirements for efficient operation with a minimum of play. They are permanently lubricated to ensure a minimum of friction and long service life. Single engine installations require two cables, twin installation require four. It is extremely important to select the exact cable lenght, fewer bends mean better operation and durability. Measure, in as straight a line as possible, the distance between the control unit and the engine/transmission connections. Calculate a radius of 200mm for all bends. Adapt the cable as shown in the illustration - L=A+B+200mm. If the measurement falls betweeen two standard cable lenghts, select the longer cable. The cables must not be cut to size! | |
 | Control cables – type 233 Available from 1.25m up to 5.00m, at intervals of 0.25m. Control cables – type 333 Available from 1.00m up to 13.00m, at intervals of 0.25m. Control cables – type 443 Available from 2.00m up to 15.00m, at intervals of 0.50m. The 443 control cables are heavy duty control cables and is suitable for use with the PC-870/871 double lever control units. This cable is recommended where longer cables are required. | |
 | Connecting kit for 443 control cable to PC-870/871 double lever control unit. | |
 | Connecting kit for joining 333 and 443 control cables. | |
.jpg) | Control cables - type X-act Available from 1.80m up to 13.40m, at intervals of 0.30m. The new generation Volvo Penta X-act control cables have been designed to provide the smoothest and easiest throttle / shift operation; while at the same time reducing lost motion. All fittings are stainless steel and plated brass. | |
 |  | Control Mechanisms Volvo Penta mechanisms are manufactured from anti-corrosion material. The mechanisms have an accelerated action which transmits lever movements into even and economic engine acceleration. For top mounting For top mounted control levers. For side mouning For side mounted control levers. |
 | Flybridge - connection fork. | |
 | Neutral safety switch Suitable for PC-740/741 and PC 840/841 control lever assembly kits. The switch prevents unintentionally manoeuvring of the vessel as it only permits starting of the engine when the gear shift is in the neutral position. | |
 | Stop cable Cable with pull handle for installation on the bridge. The cable should be cut to the required lenght. | |
